Using a Wet Tile Saw Safely

wet tiles saw is really a niche cut saw. They're tailored to the tiles. The use of water helps to cool the blade, but it also creates a slurry that lets you smooth cuts without cutting tiles.

Small chips on the surface of the tiles really don't look cool and the only sure way to avoid this is by using a wet tile saw. What scares most people when using a wet tile saw for the first time is a combination of water and electricity. You'll be correct in this, using the water and electricity together can be very dangerous and that means you need to be more careful.

The tile saw that uses a less spray generating pump and this makes it a little safer than cheap models that do not. Regardless of this, you need to care when preparing a wet saw tile, to prevent water from posing a threat.

Do not let your electrical outlet fall on the ground where the plugs in the extension cord. Place the socket over the box or anything that would lift it. No matter how it works, water will be gathered on the ground around the area where it is cut. Create a drip loop in the electric cables of wet your chainsaw tiles.

This means letting her loop a little less than the box that your socket is resting. This will cause the water that runs down the electric cord by drip from the loop on the floor and not running into an electrical outlet.

Make sure the water basin under the code is still complete. You'll need to fill it periodically. Some wet tile saws have a hose connection that enables you to run water continuously, and these will need a bucket to catch excess water. If you use a wet tile saw that does not use a pump, you need to make sure that the water sink has always enough the water for the blade to pass through-these will need to be filled often by the wet tile saws that use the pump.

You don't have dust flying in the air like you are with a regular cut saw. This may lead you to think that it is not necessary to wear eye protection. That's totally wrong. The water flowing from the cut blade contains similar particles released by the dry Cut tool in the air. This is just as bad for your eyes when you are in the shape of the water-always wear eye protection.

Otherwise, take the same precautions using my head cut off regularly. Your hands work near the blade that turns in thousands of RPM, so be careful where you put your fingers, and usually it is better to wear leather gloves when working with a wet tile saw. Though, I must say, I find leather gloves to be a very stressful matter and prefer to work without them. Only one needs to be very careful--we all prefer to keep our fingers.